View source for Faq warning saying the evriio.p file was p coded from an old Matlab version

===Issue:===

I get a warning saying the evriio.p file was p-coded from an old MATLAB version.

===Possible Solutions:===

If you receive the warning (or a similar warning) : 

<blockquote>Warning: The P-code file evriio.p was generated prior to MATLAB version 7.5 (R2007b) and will not be supported in a future release. Use pcode to regenerate evriio.p using MATLAB R2007b or later. </blockquote>

There are two solutions to this problem. The one to use depends on whether you have a full (non-expiring) license or a demo (expiring) license:

'''Full License'''

With a full PLS_Toolbox license, use the following steps to solve the problem. 

*Run <code>evriinstall</code> and follow the instructions to install PLS_Toolbox. After it is complete, restart Matlab and see if the warning messages are gone. If so, the problem is solved and you can ignore the remaining steps

*Exit Matlab

*Locate the PLS_Toolbox/utilities folder using your system's file browser (Explorer, Browser, etc)

*Locate and rename the "evriio.p" file as "evriio_old.p" (Window 7 Users see note below)

*Locate and rename the "evriio_2010b.p" file as "evriio.p"

*Restart Matlab

The message should be gone after completing those steps. If not, contact our helpdesk at [mailto:helpdesk@eigenvector.com helpdesk@eigenvector.com] . 

'''NOTE:''' Window 7 users may find that they do not have sufficient permission to make these changes if PLS_Toolbox has been installed in a folder located under the "C:\Program Files folder" (as it would by default.) In these cases, the only solution may be to re-install PLS_Toolbox into a different folder such as one located in your personal Documents folder. Follow the directions for installing PLS_Toolbox located here but specify an alternative folder for installation.


'''Demo License'''

If you receive a similar message when using a demo license of PLS_Toolbox, the problem is that you have downloaded the wrong version of PLS_Toolbox. There are two "builds" of the software available from the "Download" tab of your account at [http://download.eigenvector.com http://download.eigenvector.com]. The "Standard build" is designed for use on MATLAB versions 2007b and later. The "2007a build" is for MATLAB versions 2007a or earlier. 

#Log into your account
#Choose to download PLS_Toolbox
#On the page asking for which version of the installer you want, choose the version for use with 2007b and later


'''Still having problems? Please contact our helpdesk at [mailto:helpdesk@eigenvector.com helpdesk@eigenvector.com]'''

[[Category:FAQ]]